How To Shorten Levolor Cordless Blinds. Fixing the levelor cordless blinds involves carefully removing the blinds from the windows and placing them on a flat and clean surface. Slide them up so the eyelets are inside the bottom rail, crimp them using pliers, and cut the cords to 2 inches below the eyelets.
Page 11 of 11 trim&go! The tools that you will need for this project are a good cutter, a pair of scissors, a flat head screwdriver, and a sticky note. Yes, you can shorten cordless blinds.
Table of Contents
Remove Plugs Located Under Bottom Rail.
Move tassel up the cords to the desired end position, then tie a new knot below the tassel. Both hands should be at the same spot on the top just one at the back and on in the front. Fully lower the shade, then push the control cords through the tassel to expose the knot.
Correspondingly, How Do You Shorten Levolor Cordless Cellular Blinds?
Shutters levolor blog explore the levolor custom window coverings shopping guide, a road map for creating blinds, shades or shutters specifically for your needs. Select the slat that is even with the windowsill or slightly below it. Count 2 slats below the slat that is even with your window sill and cut both ladder cords directly below the slat (repeat for all sets of ladders).
Take A Regular Household Push Pin And Insert It Into One Of The Spring Box Holes To Lock The Spring Tension, Keep In Place Until You Complete The Last Step.
How to shorten levolor 2” faux wood cordless blinds part 1. Extend blinds and mark the desired length. Install the blind following the instructions packed with it, lower the blind fully.
How To Shorten Levolor Cordless Blinds.
If playback doesn't begin shortly, try restarting your device. Then, tuck the cords inside the rail, put the bottom slat back in place on the bottom of the rail, and pop the end caps back in place. Test new tassel location and cord length by raising and lowering.
Levolor Aluminum And Vinyl Blind Shortening Instructions 1 Levolor Aluminum And Vinyl Blind Shortening Instructions Read All Installation Instructions!
Removing more than noted will result in failure of your cordless blinds open close 42” 42” (example) the desired blind length is 42” 1 uninstall the blind and pull the blind to about 20” long. Slide them up so the eyelets are inside the bottom rail, crimp them using pliers, and cut the cords to 2 inches below the eyelets. Test new tassel location and cord length by raising and lowering blind.
